Nuts, Bolts & Hardware

2 1/2″ SQUARE NUT, BOLT, CAST IRON WASHER NOTE: Measurements in inches are across the flat of the nut. These are cast as shown in this sample. Nuts/bolts are at the ends of the “teeth” of the comb...

1 1/2″ SQUARE NUT, BOLT, CAST IRON WASHERS NOTE: Measurements in inches are across the flat of the nut. These are cast as shown in this sample. Nuts/bolts are at the ends of the “teeth” of the comb...

HINGE ASSORTMENT NOTE: Measurements in inches are length , followed by width. — Product No. 3508 — Quantity:2 sets — Exterior Measurement: longest hinge (open triangular) .50 x .100 smallest...

SCALE TURNBUCKLES-cored for .012″ wire Measurements in inches are length of turnbuckle, followed by width — Product No. 5039 — Quantity:24 — Exterior Measurement: .100, .040 — Fits Within: NA...

1 1/4″ SQUARE NUT, BOLT, WASHER NOTE: Measurements in inches are across the flat of the nut. These are cast as shown in this sample. Nuts/bolts are at the ends of the “teeth” of the comb. To apply...

2 1/2″ HEX NUT ON 6″ SQUARE WASHER NOTE: Measurements in inches are across the flat of the nut. These are cast as shown in this sample. Nuts/bolts are at the ends of the “teeth” of the comb. To...

HINGE ASST–SM NOTE: Measurements in inches are length , followed by width. — Product No. 5095 — Quantity:2 sets — Exterior Measurement: longest open hinge is .275″ — Fits Within: NA —...

1 1/4″ NUT, 3″ MALLEABLE WASHER NOTE: Measurements in inches are across the flat of the nut. These are cast as shown in this sample. Nuts/bolts are at the ends of the “teeth” of the comb. To apply...

2-1/2″ NUT, 5″ MALLEABLE WASHER NOTE: Measurements in inches are across the flat of the nut. These are cast as shown in this sample. Nuts/bolts are at the ends of the “teeth” of the comb. To apply...

1 1/2″ NUT,2″ STEEL WASHER,3/4″ BOLT NOTE: Measurements in inches are across the flat of the nut. These are cast as shown in this sample. Nuts/bolts are at the ends of the “teeth” of the comb. To...

HEX NUT ON ROUND, CAST IRON WASHER NOTE: Measurements in inches are across the flat of the nut. These are cast as shown in this sample. Nuts/bolts are at the ends of the “teeth” of the comb. To...

LIFT RINGS AND EYEBOLTS Can be used in all scales — Product No. 108 — Quantity:ASST — Exterior Measurement: center mount: .07″/.065″/.035″ DIA. side mount: .065″/.035″ DIA. — Fits Within: NA —...