HO Scale

SCALE TURNBUCKLES-cored for .012″ wire Measurements in inches are length of turnbuckle, followed by width — Product No. 5039 — Quantity:24 — Exterior Measurement: .100, .040 — Fits Within: NA...

HINGE ASST–SM NOTE: Measurements in inches are length , followed by width. — Product No. 5095 — Quantity:2 sets — Exterior Measurement: longest open hinge is .275″ — Fits Within: NA —...

1 1/4″ NUT, 3″ MALLEABLE WASHER NOTE: Measurements in inches are across the flat of the nut. These are cast as shown in this sample. Nuts/bolts are at the ends of the “teeth” of the comb. To apply...

2-1/2″ NUT, 5″ MALLEABLE WASHER NOTE: Measurements in inches are across the flat of the nut. These are cast as shown in this sample. Nuts/bolts are at the ends of the “teeth” of the comb. To apply...

STRAP HINGE ASST–SM TYPICALLY USED FOR SIDE DUMP GONDOLAS — Product No. 5118 — Quantity:2 sets — Exterior Measurement: longest open hinge is .275″ — Fits Within: NA — Additional Notes:...

1 3/4″ NUT,1 2 1/2″ STEEL WASHER NOTE: Measurements in inches are across the flat of the nut. These are cast as shown in this sample. Nuts/bolts are at the ends of the “teeth” of the comb. To apply...

4 1/2″ NUT ON RECTANGULAR WASHER NOTE: Measurements in inches are across the flat of the nut. These are cast as shown in this sample. Nuts/bolts are at the ends of the “teeth” of the comb. To apply...

1″ SQUARE NUT, BOLT, WASHER NOTE: Measurements in inches are across the flat of the nut. These are cast as shown in this sample. Nuts/bolts are at the ends of the “teeth” of the comb. To apply to...

2 1/2″ NUT,401/2″ STEEL WASHER, NOTE: Measurements in inches are across the flat of the nut. These are cast as shown in this sample. Nuts/bolts are at the ends of the “teeth” of the comb. To apply...

STRAP HINGE–LG NOTE: Measurements in inches are length , followed by width. — Product No. 5298 — Quantity:48 — Exterior Measurement: .570 x .035 — Fits Within: NA — Additional Notes: Products...

2 1/2″ SQUARE NUT, BOLT, CAST IRON WASHERS NOTE: Measurements in inches are across the flat of the nut. These are cast as shown in this sample. Nuts/bolts are at the ends of the “teeth” of the comb...

1 3/4″ SQUARE NUT, BOLT, CAST IRON WASHER NOTE: Measurements in inches are across the flat of the nut. These are cast as shown in this sample. Nuts/bolts are at the ends of the “teeth” of the comb...